Steps to install the ST-1 to your Gearhead
- Remove the bottom limb cap and O-ring from your bow. No, the limbs are not going to fly off…
- Remove the two side bolt of the swivel from the base to separate the two.
- Place the O-ring that was on the bottom of the limb cap onto the bottom of the ST-1 base.
- Attach the ST-1 base to the bow where you removed the limb cap from. A longer flathead screw has been provided. Do not over tighten the O-ring, finger tight is good!
- Reattach the swivel to the swivel base.
- Adjust swivel to your desired location and tighten.